![fl studio add reverb fl studio add reverb](https://i.pinimg.com/736x/bc/6e/41/bc6e41cf1984039c189bd7fef034f6aa.jpg)
Because if all your tracks are coming into the sub-bus super quiet, you’re forced to push the aux bus really hard to get some volume. When your route your tracks to a subgroup make sure that the tracks are loud enough. Gain Staging With SendsĪnd by leaving the faders pretty low it gives the master fader some room to breathe. Route your tracks if you want to change a group of instruments, but use sends if you just want to add parallel processing alongside the original.īut there’s more to it than that. You will only be left with more of the same, and any processing you do to the sent track will not affect the original. If you want to send the original somewhere else, to an aux bus like I mentioned before for example, you have to route the outputs of the original to an auxiliary bus.ĭon’t send a signal to a bus if you want to change it completely. What you do to the copy doesn’t affect the original at all! Now you have the original on the same track, but you also have a copy playing in your aux track. Many engineers don’t realize that by sending tracks you are still left with the original track. I sent all my tracks to an aux channel, added some EQ and compression and then wondered why my filters weren’t clearing up the low-end and my compressors weren’t taming my dynamics?īecause sending isn’t the same as routing. All the way back when I was just starting to mix, I used to do this really simple mistake.